2. amps-preamps
  3. 164566-137654

Preamp or not.

I currently have the following setup Bluesound Node 2I, Topping D90, Pass XA25, Crites Type B speakers.
I originally had a Sunfire preamp but it failed. Then I upgraded my system last year. I tried a passive pre amp but removed it and now run the DAC direct to amp. The passive sounded fine but I ended up running it at full volume. No remote. I use the Bluesound ap to change volume. My thinking was less is better. My speakers are efficient and dynamic.

The Topping puts out 2V. Pass told me this is adequate. I am wondering what a preamp would do. How would it improve or degrade the sound? How much gain do I want from the preamp? Tube or solid state? Any other suggestions are welcome or should I just leave this alone? I don’t like buying, selling and failing. Here are some I saw that look interesting.

Pro-Ject Pre

Doge

Modwright

Van Alstine

I would like to spend 2000 or less. I don’t need Phono. Remote volume would be nice. Thank you again.

128x128daledeee1
raysmtb1's avatar
Ag insider logo xs@2x
raysmtb1
800 posts
 
I would consider a preamp with some tone control.that way you adjust some of the older recordings 
daledeee1's avatar
daledeee1 OP
563 posts
 
I finally understand the volume thing and explains "sounds better if it's turned up".  Much thanks @mlsstl .  I hope I wouldn't get too sensitive with the volume meaning small adjustments equal big volume swings.  The extra power supply might be a tradeoff for sensitivity.  Is that correct?  The speakers I have are about 100dB efficient(or higher)
mlsstl
1,436 posts
 
Power and sensitivity should not be an issue for you. The Pass amp needs roughly 1.25 volts input for its full 25 watt output at 8 ohms. Your Topping, at 2 volts max out, has more than enough to drive the Pass, so with your efficient speakers, you’re going to need to be cutting volume quite a bit (unless you are a full tilt all-the-time head-banger.)

So, the question becomes, what is the best tool for controlling the input voltage to your amp? You don’t need any more gain, so that points to a totally passive or unity gain analog preamp. This would allow you to run the digital signal at 100% (no bit loss) but still control the volume to your liking.

Besides the Saga+ mentioned before, Schiit also has a totally passive volume control -- the Sys, for only $49. But, it has no remote. Others have suggested other excellent preamps, though you’d want to consider the gain issue in choosing one of them.
adg101
1,062 posts
 
I have a ModWright LS36.5 that I recently pulled out of the system and running a RME ADI 2fs DAC with a Teddy Pardo supply direct to my Pass. It sounds great direct and I’m in no hurry to throw the MW back in anytime soon. The RME/Teddy is so clean and revealing and is not missing anything the MW offers, but the noise floor is much lower that the littlest of detail doesn’t get lost and the bottom end is on another level. Before I spent anything over $1,600 I’d consider the RME/Teddy combo if you’re not spinning vinyl, which I do so I will be keeper my ModWright for now. The ModWright is still a great preamp so if a must to get a preamp they’re highly recommended. Before my LS36.5 I had a SWL 9.0 SE and that too is a killer preamp... not as revealing as the LS37.5 but still outstanding.
rh67
307 posts
 
The LTA headphone pre-amp combination sounds wonderful with the XA25 and it`s well under 2k. I have been using this combination for the last year. I have a Supratek DHT pre coming soon to pair with my XA25, DHT`s for me add more realism.
More to discover