I am a carpenter/woodworker w/ 45-50 yrs experience. MC has given good info. However, the shrinkage is calculated for RAW wood. Sealing the wood is necessary. IMO, its NOT an option. It seals the wood against shrinkage. Does that mean there will be NO shrinkage? No. Most woodworkers shoot for 7-8 %. This is the percentage that is usually achieved in a kiln. Air dry is 10-15%, depending on how long it is left to dry. I only use kiln dried which is safer. However I have a friend who has used a lot of air dried with good results. I won't take the chance on that. But many do. That said, I have an all wooden turntable including the platter. The platter is made with a resin and covered with a veneer (cocobolo). There is no cracks whatsoever in it. There are a few minor surface cracks in the veneer on the plinth. But they are small and have no effect on the sound. I also have built a stand with sand box on top using wood. Again, I'm sure the wood moves some but what is the detrimental effect? I think none
Another problem encountered is the use of thick boards. They retain more moisture than the thinner stock. And most racks use 2 inches thick or more. IOW, the moisture content which is sealed in can cause a problem & often can cause problems. It can be remedied so as not to crack but that adds cost. Often thicker stock is air dried. And air dried material is less expensive.
So the question is not whether the wood moves? Most everything does expand & contract with weather change. Steel does , although at a much lower rate. The question to me is this. Does the movement cause troubles. I don't think it does. But in the end, everyone must choose for themselves. Considering the low humidity levels that Timber Nation specifies makes me believe they probably use air dried material. My own house fluctuates between 30 & 55% humidity. According to their specs, I doubt any house in the nation would be an appropriate candidate for their racks unless they use humidifier in winter and dehumidifier in summer, which is more exception than rule.
Another problem encountered is the use of thick boards. They retain more moisture than the thinner stock. And most racks use 2 inches thick or more. IOW, the moisture content which is sealed in can cause a problem & often can cause problems. It can be remedied so as not to crack but that adds cost. Often thicker stock is air dried. And air dried material is less expensive.
So the question is not whether the wood moves? Most everything does expand & contract with weather change. Steel does , although at a much lower rate. The question to me is this. Does the movement cause troubles. I don't think it does. But in the end, everyone must choose for themselves. Considering the low humidity levels that Timber Nation specifies makes me believe they probably use air dried material. My own house fluctuates between 30 & 55% humidity. According to their specs, I doubt any house in the nation would be an appropriate candidate for their racks unless they use humidifier in winter and dehumidifier in summer, which is more exception than rule.