2. speakers
  3. 147808-7805

Cube Audio Nenuphar Single Driver Speaker (10 inch) TQWT Enclosure

Cube Audio (Poland) designs single drivers and single driver speakers. 

Principals are Grzegorz Rulka and Marek Kostrzyński.

Link to the Cube Audio Nenuphar (with F10 Neo driver) speaker page: 

https://www.cubeaudio.eu/cube-audio-nenuphar

Link to 6Moons review by Srajan Ebaen (August 2018):

https://6moons.com/audioreview_articles/cubeaudio2/

----------------------------------------

Parameters (from Cube Audio):

​Power: 40 W

Efficiency: 92 dB

Frequency response: 30Hz - 18kHz ( 6db)*

​Dimensions: 30 x 50 x 105 cm

Weight: 40 Kg


* Frequency response may vary and depends on room size and accompanying electronic equipment.
david_ten
david_ten OP
5,480 posts
 
@abd1  I went with the unthreaded version of these:

https://edensoundaudio.com/shop/hemispike-extra-large/

I used commercial / industrial grade double sided adhesive discs.  I have not had any slippage.

The bottom rear cabinet area can be drilled, but it is tricky and there is a chance one may damage/crack the finish.
abd1
157 posts
 
@david_ten So did you just wrap the adhesive discs around the hemisphere threads and insert? I have the hemispheres but haven't installed and still using the stock rubber bumpers. Where did you get the discs? Thanks.
david_ten OP
5,480 posts
 
@abd1  The unthreaded versions have a flat surface. 

I used this or something similar: 3M VHB double sided.

https://www.theclip.com/store/3m-vhb-double-sided-adhesive-small-round.html?gclid=CjwKCAiAkJKCBhAyEi...


abd1
157 posts
 
@david_ten ok I get it. I bought the threaded ones, oops. Thanks. 
david_ten OP
5,480 posts
 
If not returnable, you could cut the threaded section. If it is an insert, you can remove it and use the adhesive disc (which will cover the insert hole).
More to discover