@david_ten how did you install the rear brass bumpers on your Cubes? Did you have to install threaded inserts? Thanks
Cube Audio Nenuphar Single Driver Speaker (10 inch) TQWT Enclosure
Cube Audio (Poland) designs single drivers and single driver speakers.
Principals are Grzegorz Rulka and Marek Kostrzyński.
Link to the Cube Audio Nenuphar (with F10 Neo driver) speaker page:
https://www.cubeaudio.eu/cube-audio-nenuphar
Link to 6Moons review by Srajan Ebaen (August 2018):
https://6moons.com/audioreview_articles/cubeaudio2/
* Frequency response may vary and depends on room size and accompanying electronic equipment.
Principals are Grzegorz Rulka and Marek Kostrzyński.
Link to the Cube Audio Nenuphar (with F10 Neo driver) speaker page:
https://www.cubeaudio.eu/cube-audio-nenuphar
Link to 6Moons review by Srajan Ebaen (August 2018):
https://6moons.com/audioreview_articles/cubeaudio2/
----------------------------------------
Parameters (from Cube Audio):
Power: 40 W
Efficiency: 92 dB
Frequency response: 30Hz - 18kHz ( 6db)*
Dimensions: 30 x 50 x 105 cm
Weight: 40 Kg
* Frequency response may vary and depends on room size and accompanying electronic equipment.
- ...
- 1567 posts total
@abd1 I went with the unthreaded version of these: https://edensoundaudio.com/shop/hemispike-extra-large/ I used commercial / industrial grade double sided adhesive discs. I have not had any slippage. The bottom rear cabinet area can be drilled, but it is tricky and there is a chance one may damage/crack the finish. |
@abd1 The unthreaded versions have a flat surface. I used this or something similar: 3M VHB double sided. https://www.theclip.com/store/3m-vhb-double-sided-adhesive-small-round.html?gclid=CjwKCAiAkJKCBhAyEi... |
- 1567 posts total