You would run dual balanced outputs, one set to your main power amp. The other set would go to the ISO MAX units (left and right channels). Only at that point would you use RCA connections, between the ISO MAX units and your sub. So the ISO MAX units would be right by your sub so you could run a longer balanced line connection from the preamp to the ISO MAX. If you don't have dual outputs on the preamp, you would use some form of a Y adapter to make it happen.
Cons of using main XLR/Balanced outs for subwoofer?
I'm putting my system together for the first time in a new space with a new to me preamp and new speakers.
Signal Chain:
TT/Streamer
McIntosh C220
McIntosh MC7270
Ohm Walsh 4.4012
The 7270 does not offer balanced inputs.
The Ohms have active subs which offer balanced input.
The C220 has only one Balanced output for the Main Output.
Is there any harm in using the main XLR output to send signal to the subwoofers, and using the 1, or 2 RCA output to send signal to the main drivers?
Thoughts?
Thanks
z
Signal Chain:
TT/Streamer
McIntosh C220
McIntosh MC7270
Ohm Walsh 4.4012
The 7270 does not offer balanced inputs.
The Ohms have active subs which offer balanced input.
The C220 has only one Balanced output for the Main Output.
Is there any harm in using the main XLR output to send signal to the subwoofers, and using the 1, or 2 RCA output to send signal to the main drivers?
Thoughts?
Thanks
z
- ...
- 33 posts total
Dear @zdw11 @cardani : I can see that both of you are running your main speakers/subs to listen MUSIC ( at least do not posted for HT. ). Now in the Ohm speakers the sub is part of the speaker ( I don't know forsure all the subs controls to operation. ). If we want to listen in specific MUSIC through our room/system and want to add subwoofers the rigth way to do it is that those pair of true self powered subwoofers crossover ( should be. ) around 80hz-90hz but this crossover frequency is not only for the low-pass subs but we need and should be that the main speakers been too crossing around that frequency with the high-pass filter and in this waythat room/system will takes a true advantages to add subs to listen MUSIC because in that way the main speakers will be handling frequencies from 80-90hz and up and the IMD and THD distortion levels that existed in those passive speakers goes really lower in benefit of higher sound reproduction quality level and at the same time that room/system will handled with accuracy the low bass range and even can goes lower in that range. Due that I don't know of the overall Ohm speaker operation then I could be wrong with but with the other gentleman that's the rigth way to integrates subwoofers to MUSIC soun reproduction as our main system use. Here a link about: https://forum.audiogon.com/discussions/do-you-think-you-need-a-subwoofer/post?postid=310058#310058 Of course that one thing is what " should be " and the other what we like/want so in this specific subject everything is up to you and this post is only an opinion and nothing more. R. |
@atmasphere Ralph ... I have two main outs - one is balanced and one is single ended. The balanced goes to my power amp directly. The single ended goes to the sub directly. If I used the ISO-MAX, then it would appear I'd just go from the single ended output into the ISO-MAX and then go single ended into the sub. Will that configuration really make a big difference? Thanks. |
Will that configuration really make a big difference?@rlb61 Did you notice a difference in the mains between not having the sub hooked up and all, and having it connected but its volume turned all the way down? If there is no difference then your RCA output is buffered from the balanced out and the ISO MAX isn't needed. If there is a difference then this is the solution. |
Dear @rlb61 : You own very good two-way speakers with a " little " trouble and this is that crossover at 2khz so the woofer runs frequencies from around 35hz to over 2khz and no matters what that facts says that the IMD and THD distortion levels are higher than desired to listen MUSIC. I know that you are not really happy with your JL sub: """ I’ve concluded that a subwoofer is not necessary in every application where a 2 way speaker is used .. """ by the contrary the conclusion is the other way around: with a two way speaker design subs always are need it. I know too that your room is not to big but this does not avoid the sub use or integration. The first premise to add subwoofer to any system is that must be a pair of self powered subwoofers and never only one unit, this is not the way to go. You need a pair of subs and if you follow the information in the link I posted you will be way satisfied with. Now, adding a pair of subs running in stereo way is not plug and play we need time and patience and if you have it then you will have success. Your Pulsar will shines as never before and you will have all the frequency ranges at the higher quality level performance you can imagine: really good an accurated bass range handled by dedicated woofers and dedicated amplifiers and the same in the mid/high ranges where your main amps will performs better than ever when are not running low frequencies that diminish its overall quality performance and headroom, now you will have pristine and addictive Pulsar MUSIC sound reproduction. Remember, you need two subs. As I said in other post: is up to you. R. |
- 33 posts total