2. digital
  3. 164884-158650

I2S setting using Denafrips Pontus and Iris

Hello, I'm new to this forum so I hope I am posting in the right place.
Can you help me please?
I have a Denafrips Pontus and I have just purchased as Iris. I may send the Iris back soon and order a Gaia instead. I have used a spare cheap Amazon HDMI cable from the Iris Out to the HDMI (i2s) Input on the Pontus.
I followed the instructions on the Vinshine youtube website:
I put my Pontus on to the i2s input.
I pressed the Mute button. the lights cycle.
I clicked the Phase button repeatedly.
On two of the "clicks" of the phase button I get sound but with terrible distortion.On all the other settings I am getting good sound.

Why am I getting sound from more than one of the "clicks"? I am not sure if one sounds better than the other yet but surely as the Pontus and Iris are both made by Denafrips then one of the settings I choose should be the correct one?

Also, would I get a better sound by using an HDMI cable that has the video pins removed? If not, using a standard HDMI cable, what would you recommend please? I can hear a big difference when using different makes of USB in my system so I assume a decent HDMI cable would be the way to go as well.
Finally, am I doing the right thing using i2s or would any of the other outputs on the Iris be a better way to go?

Thank you for your help.
dyson2004
alvin1118
131 posts
 
The i2s pinout of DENAFRIPS DAC need to be set correctly in order to work with the i2s source. I use Audio Tone Test utility (Tidal) to help me with the Left/Right channel, and in-phase/out-of-phase test.

The correct setting of the I2S of the DENAFRIPS DAC to match with the DENAFRIPS DDC is '000', i.e. 1x 2x 4x LED off.

As soon as the i2s pinout is set correctly, you should be able to play both PCM and DSD without noise.

Video Guide: https://youtu.be/oXwtbMK1iHI

Noted: Turn the volume down when you configure the i2s setting :)

I can be reached at sales@vinshineaudio.com

Happy to help!

Many thanks,
Alvin @ www.vinshineaudio.com
Post removed 
rikkipuu's avatar
rikkipuu
278 posts
 
@dyson2004
https://www.youtube.com/watch?v=Z3i3JfqrrXo
check out this video.  It took me a while to get it, but after selecting the proper I2S output you can set the configuration.  Hit the mute button followed by the phase button.  The terminator wants the PS audio standard of 100.  So that is the 1X light on and the 2X and 4X lights off (100), after about 10 seconds the setting will hold and your good to go.
The HDMI cable is important, Alvin recommended this
https://usashop.sommercable.com/en/Cable/HiFi-Home/Multimediakabel-EXCELSIOR-BlueWater-EBH4.html
it was better than an Audioquest Coffee
rikkipuu's avatar
rikkipuu
278 posts
 
whoops my bad I did not see Alvins post it wants 000 not 100
dyson2004 OP
42 posts
 
I used test tones to sort out which i2S configuration is the correct one using the Iris to the Pontus. All it needs is the 2x light to be set on the Pontus. That way the stereo image (and phase for my system) are correct.
More to discover