Interesting. So what do you think would be best with the 3D printed “block” quadratic diffuser:
1) “Solid” infill
2) Hatched infill
2) Hollow infill with a dampener like dynamat on the back sides of the blocks
3) Solid infill with a flat back and attached to a block of wood or other substrate.
I’m thinking of putting these diffuser panels in the center and behind the speakers because I’ve seem many a fancy setup do this (they must have a good reason 🙂) and because it gives you something interesting to look at while listening as opposed to a wall or flat absorbent sound panels.
1) “Solid” infill
2) Hatched infill
2) Hollow infill with a dampener like dynamat on the back sides of the blocks
3) Solid infill with a flat back and attached to a block of wood or other substrate.
I’m thinking of putting these diffuser panels in the center and behind the speakers because I’ve seem many a fancy setup do this (they must have a good reason 🙂) and because it gives you something interesting to look at while listening as opposed to a wall or flat absorbent sound panels.