Is there a quality difference sound vise between balanced output and rca output on these dac’s ?
Looking for a DAC under 2k
I'm using a Small Green Computer Optical Rendu to bring usb to a DAC.
Looking for a new DAC around 2k new or used.
Recently, I had a Border Patrol Se-i which sounded beautiful with a great soundstage and a relaxed sound. Unfortunately, dynamics and bass definition were weak.
Next up, I tried the ifi Pro iDSD. Detailed and clean, but lots and lots of settings to play with. Became noisy after a couple hours and eventually stopped putting out sound and went silent. Can't deal with that kind of poor quality, but really would have prefer a little warmer sound.
I borrowed my Chord Qutest from my headphone system. Very good with my tube headphone system, and not bad on the speaker system, but would like something a bit more analog sounding, like a Border Patrol with dynamic punch and clearly defined, not muddy bass.
TIA, for suggestions.
Looking for a new DAC around 2k new or used.
Recently, I had a Border Patrol Se-i which sounded beautiful with a great soundstage and a relaxed sound. Unfortunately, dynamics and bass definition were weak.
Next up, I tried the ifi Pro iDSD. Detailed and clean, but lots and lots of settings to play with. Became noisy after a couple hours and eventually stopped putting out sound and went silent. Can't deal with that kind of poor quality, but really would have prefer a little warmer sound.
I borrowed my Chord Qutest from my headphone system. Very good with my tube headphone system, and not bad on the speaker system, but would like something a bit more analog sounding, like a Border Patrol with dynamic punch and clearly defined, not muddy bass.
TIA, for suggestions.
- ...
- 69 posts total
@gryphongryph Always, I suspect. There are a few things to consider in the balanced vs. single ended (RCA) world. You really need to know if the equipment internally balanced by design. If so, then you’re getting reduced distortion because of the noise rejection properties of the design scheme. While this is great for getting rid of noise, it also throws away all even-order harmonics in the distortion profile, leaving only odds. If you read about 2nd harmonic distortion, you’ll see that it actually creates an impression of warmth, body, and 3-dimensionality... and is preferred by some -- but not all -- listeners. For fun, Nelson Pass has actually made a H2 generator that literally injects negative phase second harmonics into the signal path. Like I said, not all ears hear this the same way, though, so you may prefer 3rd order harmonics (or neither), in which case it makes sense to minimize distortion and go fully balanced throughout the system. So, if the equipment is fully balanced, then you’re throwing away the benefits by using the RCA outputs. If it’s single ended by design, then using the XLR outputs means that the signal is being pushed through a transformer or op-amp circuit to convert from single-ended to "balanced". In this case, you’re not getting any of the noise rejection benefits of the balanced circuitry. Instead, you’re getting whatever the sonic signature is of the added iron or circuitry. I’d say that’s an obvious compromise, but some people do like the sound of a high quality transformer, so perhaps you’ll find it a pleasant addition. |
cal3713 - I do understand the difference between bal and rca, was more thinking about the implementation. Even though I have balanced equipment, I am leaning to the camp that balanced is overkill in home Hi-Fi and that the money would be better spent in better parts or single ended development, also for balanced to make any sense, one has to use it all trough the chain! Off course if the buying budget is is of no concern, then please buy balanced 😜 I find this interesting. http://www.pureaudio.co.nz/?page_id=270 |
Here is a good Chord Qutest review: https://www.stevehuffphoto.com/2021/01/17/hifi-the-chord-mscaler-with-chord-qutest-dac-review-end-ga... |
- 69 posts total