What phono preamp are you using?

Air Tight ATE2. 2 phono MM inputs and 1 Aux. Phono section driven by 12AX7 (ECC803S telef(3). Line section : 2 Ecc88 (in my case replaced them by nos E188cc).
PSU incl :  12BH7 (nos Tungsol Sol), 6X4 (nos GEC), EF86 (E80F for me is the best EF86 if you have enough room inside the pre).
If you connect the Air Tight ATH2 step up in one phono input you can drive 4 different carts. Sound is very very good and reliability is of the highest level.
NOS tubes helps to cook your preferred sound.

Rogers PA-2 with Hana SL1200. Was going to upgrade TT rig but decided to go for a deal on a used PA-1A and have it upgraded. Don't have it back yet (waiting with bated breath) but when I originally plugged it in I could not believe the difference it makes. I still want to upgrade the TT rig at some point but this is better enough by a lot that it's cured my upgradeitis. Thinking this might be the end game phono pre for me. 

Use either an NVO all tubed unit or Gold Note PH10. So different but NVO always sounds fantastic in either MM using a step-up or MC straight in. 

Soundsmith Zephyr (medium output) and Zephyr MIMC (low output) with a Manley Chinook. Vintage tubes in the Chinook.

Hello
I went through multiple phono pre’s before I popped on a Sutherland 20/20 with Lyra Delos cart.  If you want super quiet low noise and have potential for hum,the Sutherland is a good choice.  This is a great combo and I also just replaced a Scout 1.1 Shri a new Pure Fidelity Encore table with Origin Live Silver.
I’m done...... for a while!
Good luck Willy-T