What did you use for polishing ?I think we had already discussed it in the past; a simple copper cleaner
Before https://i.postimg.cc/VNrkfbsd/Prima-1.jpg
Technics SL1000 MK3 (SP10 MK3) performance/value VS modern turntables?
I have a Technics SL1000 MK3 in beautiful condition and in it's lifetime has seen very little use.
I am ready to send it off for complete electronics restoration/upgrade, upgrade the speed control processor module and have the Krebs mods done. Will cost about $2500.00 to have all this done.
I was wondering how this would compare to what is out there for modern turntables after all the work is done?
Or, would I be better off selling it, and adding what I was going to spend for the upgrades to a new turntable?
I believe these should sell in untouched condition for at least $5K? So that would put me in the $7.5K range for a modern table?
For tonearms, I already have:
New, unmounted Moerch DP8
Fidelity Research FR64S, in beautiful condition that I sent off to Ikeda/Japan and they re-wired (better silver wiring, I still have original wires) and completely tore it down and rebuilt/re-lubed.... it's just like a new FR64S.
I think this table would be hard to beat at the $7500.00 price point, but would appreciate others opinion.
Rick
I am ready to send it off for complete electronics restoration/upgrade, upgrade the speed control processor module and have the Krebs mods done. Will cost about $2500.00 to have all this done.
I was wondering how this would compare to what is out there for modern turntables after all the work is done?
Or, would I be better off selling it, and adding what I was going to spend for the upgrades to a new turntable?
I believe these should sell in untouched condition for at least $5K? So that would put me in the $7.5K range for a modern table?
For tonearms, I already have:
New, unmounted Moerch DP8
Fidelity Research FR64S, in beautiful condition that I sent off to Ikeda/Japan and they re-wired (better silver wiring, I still have original wires) and completely tore it down and rebuilt/re-lubed.... it's just like a new FR64S.
I think this table would be hard to beat at the $7500.00 price point, but would appreciate others opinion.
Rick
- ...
- 87 posts total
And the best for Micro mats is Micro clamp, this is very rare one. |
I’ll add that other mats I like are the Sakura graphite "The Mat" and the thicker Funkfirm Acromat. The former is laudably neutral although less dynamic and immediate on transients than the TTM; the latter has excellent dynamics, similar in that regard to the TTM, but loses some drive, bass weight, and definition. At least on my turntable. |
- 87 posts total