So done with audiophile fuses


The journey started with a medium priced ($50) fuse in my power supply.  A failed rectifier tube blew that one out.  Not a fuse problem.  Next up was a blue fuse in my pre amp.  It blew and was not caused by a pre amp problem.  Apparently they sometimes are more sensitive and it was replaced by an orange fuse two values higher.  Things were going along fine.  I replaced the pre amp with a newer version of the pre amp and it has the same fuse value.  Five months latter (today) I turn on the pre amp and nothing.  it's a five month old pre amp so I suspected that it was the fuse.  Sure enough, I replaced it with a ceramic Littelfuse of the lower correct value it works fine.  No more wasting my money on unstable fuses for me.     
goose
jhills
It is a mis conception that a faulty component that takes damage when its fuse does not blow, will instantly trip a 15A or 20A circuit breaker before enough damage is done to start a fire in the component. In most cases it will not. If your faulty component doesn't blow a 10A fuse (where there should have been a 3A or 5A fuse) before causing damage or fire, don't expect it to trip a 20A circuit breaker.
Agreed 100 percent. A circuit breaker's job is to protect the wire in the wall. Nothing else.
...and a fuses job is to protect from a fire in your home or listening space. Electrical fires are the worst.
edgewound"a fuses job is to protect from a fire in your home or listening space"

This is inaccurate, wrong, and false it is to protect the component and possibly a device connected to the component it is not to protect the listening room that is silly and mistaken.
The job of a safety fuse in a component is to protect the cord that is connected to that unit in case there is a serious short in the unit.  Additional fuses may be added to protect the component itself.  Where safety items are being discussed, its is dangerous, ill advised, unwise to comment where you lack knowledge.