Anyone here have experience with the Denon DP-35F?

I know thats what the factory manual says, but like I said, I’m pretty sure mine had the DL160. I know this because when I bought the table I was told not to get any table with an MM cartridge, always buy MC. I heard that lecture any time I was shopping or even talking about a table. The guys in the store hooked me up since I was there part-time. This was 1985, I think. I had looked at the cartridge numerous times at home and I remember seeing "DL160" on the body. 

I like Denon DP-80 turntable and Denon DA-401 tonearm. I also have Denon original plinth for my DP-80.

If you want Denon cartridges you can look for DL-103D or S. 
Or you can look for MM cartridges like DL-107 if you want that denon sound.

Pickering XSV/3000 and Stanton 881 are great at your price and probably better.

Thank you, I'll look into those. I didn't know Pickering was still in business. 

Pickering and Stanton are still in business, but audiophiles are not their target market anymore, since Walter O. Stanton sold the company in the late 90s. However, best cartridges from the 80’s - early 90s still can be found NOS (I bought many and was lucky). Two models mentioned above are about $350

It’s the DP80 and the DA401 that are no longer available new from a dealer. If you find a Dp80 in good shape, and I agree it is a worthy pursuit, I advise you to have it serviced by a competent technician. If the DP80 has not been serviced since new, then most likely it will need new electrolytic capacitors. The parts are dirt cheap; you would pay mostly for labor. After that, if the unit is faulty, the next place to look is at the single integrated circuit responsible for speed control. The popular myth is that the chip is no longer available. Not so. Also, some of the discrete transistors, while not necessarily defective, can be replaced by modern equivalents that work better. You could live with the original transistors, but a smart tech will upgrade them. If you are in the NE USA, I recommend Bill Thalmann in Springfield, VA. All of this will cost maybe a few hundred bucks and is well worth it. Beware also of 100V units from Japan that have been run on 120V in the USA. That often damages the single IC in there. In my opinion, the DP80 is the best bang for the buck in vintage DD turntables. I emphasize that’s only my opinion.

Yes, I recall a friend replacing an older Red Denon (#?) with a 160 around 1986 so that would make sense.

DeKay