No, You Cannot Bi-Amp

Hi macro -

yes - that's exactly what i did.
I'm not using an external crossover (although many tell me it's the way to go).
It sounds so good with the bi-amping and the crossover that came stock.

I think one of the reasons that bi-amping is a lightning rod is that there is much misinformation or opinion masquerading as fact.

People also mix non-compatible gear, like a fast SS amp with a 'slower' tube amp on the highs. (strongly held opinion) While not taking into account the latency of the amps being used, can introduce phase effects. (maybe testable)

The endless combinations of filter choices, points, slopes and type just feed the fires.

I'd suspect (again, opinion) that a properly setup (yet more opinion) bi-amp system could yield positive results.

I couldn't imagine my Panels NOT benefiting from a pair of same amps, given the close to 50:50 power distribution crossover point of 600hz.

Some good points have been made above. With respect to passive biamping, another commonly overlooked point is that in that arrangement both the high frequency amp and the low frequency amp have to output the voltage range of the full range signal. Which means that if a low powered tube amp is used for the highs and a much higher powered solid state amp is used for the lows, most of the power capability of the solid state amp will be unusable and wasted, because the maximum volume setting that can be utilized will be limited by the clipping point of the low powered amp. Also, of course, gain matching is likely to be an issue in that situation.

Regards,
-- Al

Relative power needed is almost entirely governed by crossover point.

If you crossed over at 10khz, you could make due with a 30 watt tube amp on top of a 300 watt SS.

Than, other issues would come to the fore.

01-20-12: Magfan
Relative power needed is almost entirely governed by crossover point.
If you crossed over at 10khz, you could make due with a 30 watt tube amp on top of a 300 watt SS. Than, other issues would come to the fore.

Right! A major "other issue," if the two amps are being used in a passive biamp arrangement (i.e., without an active crossover ahead of the power amps) being that some number approaching 270 watts of the 300 watt capability of the SS amp could not be utilized, without clipping the 30W amp. Essentially the 300 watt amp would be reduced to not much more than a 30 watt amp in that scenario (the exact value depending on the voltage swing capability of the 30 watt amp). Which was exactly my point.

Best regards,
-- Al