2. cables
  3. 167185-11297

In term of construction, what's the difference between cheap vs. expensive power cables

When it comes to interconnects and speaker cables, it is easier to understand the justification for the costs of these cables.  But when it comes to power cables, it is a little difficult to understand.

Some believe that as long as the power cable has enough gauge the that's all you need.  I've used some cheap power cables vs. some high price cables and there are clearly differences in sound, so the "gauge" of the cables is not the ONLY thing and it's a little bit more complicated than that.  

In speaker cables design, you can adjust the R/L/C parameters to achieve a certain kind of sound and it's easy to visual how these parameters will affect the sound.  For example too much C then the sound will lack leading edge.  Too much L then the sound will be brittle.  If too much R then the sound will lack dynamic.  Or if the cable has too much jitter, then the transparency will be affected.

But the power cable main job is to establish a DC source, it's not too clear how the R/L/C parameters will affect the sound the same way these parameters will affect the sound of the speaker cable.  Also I am not sure how jitter would affect a power cable either

So the bottom line is what's actually inside a power cable that make them so expensive?  Do they use fancy dielectric?  How about construction geometry?  

For a designer, I mean how do you fine-tune your power cable.  How do you know your power cable will sound good?
andy2
invalid
1,085 posts
 
Are AC line-treatment devices necessary? Define necessary. "We try to build equipment that puts up with dirty AC lines," Pass told me. "Our customers expect it, and if they have a problem, we hear about it. We don’t design around the assumption that there is AC line conditioning in the system. That said, if the line conditioning has adequate current capacity, we expect some benefit."

You should read that last part a couple more times so that it sinks in.
Post removed 
pauly
1,012 posts
 
@invalid - I nearly ruptured my spleen laughing when I saw your post.

@andy2 - When I was discussing my requirements with the folks at Wireworld they told me that the shortest PC they recommend is 2 mtr, and suggested I use 3 mtr lengths - which I did. I assume they dial in a little bit of capacitance in their PC’s, but have to hold back lest it causes issues with longer cords.

I compared a 1mtr silver electra to a 3mtr silver electra and the 3 mtr does result in an audibly better sound. It’s subtle but its there.
andy2 OP
1,526 posts
 
After reading through a few of your posts it’s pretty obvious that you don’t have much of a clue about Audio.
I guess you do.  Maybe you can educate the rest of us, young Luke?


Post removed 
More to discover