2. amps-preamps
  3. 167371-79729

Krell KSA 200s power feed

Hi All.

I wanted to know what your experience is and opinion on powering this amp.
https://www.stereophile.com/solidpoweramps/694krell/index.html


I live in Australia, so our power is 230 volts and 10 amps.
We have always used this amp directly into the wall.
But reading through the manual I can see it’s recommended to have 20 amps into the amp.
I don’t notice any sonic issues with running it directly on 10 amps.
I wanted to know what your opinion was as I was getting an electrician to put some additional power points and whether I should get him to wire a 20 amp line just for the Krell.
128x128kunalraiker
invalid
1,194 posts
 
I believe krell must word their manual for 120 volt lines. I have the ksa 300s on a 20 amp breaker, but it's a 120 volt line. You only need half the amperage when the voltage is doubled.
gs5556
1,235 posts
 
Going by amps can be confusing, use apparent power instead, which is voltage times amps. Krell recommends a 2400VA power supply from the wall which is 20 amps at 120VAC (2400/120) or 10.4 amps at 230VAC (2400/230). 

The only issue I see is protecting the amp. In the US, we have to reduce the fuse size by half if you go from 120 to 240, and it could be a reason why voltage changeover is usually not user selected -- the user will forget to change the fuse.
invalid
1,194 posts
 
The only issue I see is protecting the amp. In the US, we have to reduce the fuse size by half if you go from 120 to 240, and it could be a reason why voltage changeover is usually not user selected -- the user will forget to change the fuse.


I never thought of changing the fuse if going up in voltage, but it makes perfect sense.
kunalraiker's avatar
kunalraiker OP
45 posts
 
I got the audio wired to 10 ams dedicated from the switch board with individual circuit breakers.
As Iam in a 240 volt region, thanks all for your advise.
ebm
9,311 posts
 
Yes get a bigger line it will give you more dynamics for sure.
More to discover