DeoxIT on cables/Jacks?

Please clarify:  

It doesn't remove oxidation from metal surfaces therefore it will not improve sonics? 

Or, removing oxidation from metal surfaces doesn't improve sonics?

- Thanks.

It is claimed to remove oxidation from metal surfaces. If it works, good! Will it improve sonics? I doubt it!

Deoxit makes a noticeable improvement in sonics. More clarity, less grain; subtle, but obvious gain in overall refinement. Do your interconnects also!

Take Qtips (not the plastic stick version) and pull the cotton off the ends so that the “stick” is bare, or with only the thinnest layer of cotton left. Dip or spray the ends with Deoxit, stick in the ground flanges of your interconnects’ male RCA connectors and twirl around inside. You’ll be amazed at their dark color afterwards.  Then do the same for the inside of the female RCA connectors on your amp. Don’t reuse. Use clean Qtips for each connection.

You will hear the difference.

@racked, Not recommended for tube sockets according to manufacturers. You don't want to leave any residue inside the socket. 
Also, when using on tube pins, wipe off all the gunk and make sure pins are dry before using.

I personally find more sonic improvements from cleaning and tightening  very dirty or loose connections than from fancy cables (past a certain point of quality)> This, though, presumes they are dirty. One effective way to clean them is to insert/remove. For connections without a wiping action Deoxit or cramolin is a good idea. CRC also makes very good cleaners and lubricants/oxi barrier products.
So, yes with caveats

I have my own concoction. It leaves a light conductive film after it’s wiped off. Like most conductive liquids at + or - 50 degrees from ambient temperature it reduces micro arching (noise) and INCREASES the actual surface area of contact. Does the sound improve?

Do you like popcorn IN your music or WITH your music..

MAINTENANCE, pays it doesn’t cost.

It’s always better to stay out of trouble, than get out of trouble..

Of course it sounds BETTER. Cables and ALL connection require service at some point in their life cycle.

Worst offenders are jumper bars on speakers and preamp/amp jumpers..

BUT any connection point from the wall to the jumpers between HIGHS and LOWS at the speaker terminals..

Tube sockets.. LOL oh yea make sure they are drippin’ when you flip the on/off switch.. Use good sense.. Dab and dry with cotton balls and air dry with low air pressure.. BTW Ear muffs on while blowing.. Always..

CLEAN & DRY is good with electricity..

Regards