How to isolate turntable from footstep shake or vibration

@atmasphere and @lewm , I can tap on the 6922's in an ARC PH3SE and hear absolutely nothing with the volume turned up. I'm sure if I tap hard enough I could get an audible result. But tapping on the tube would have a lot more energy then you would get with air bourn vibration. I use super quiet tubes. My instinct is if a unit is sensitive to tube microphonics perhaps you might consider another unit. My only current experience in regards to tubes is my phono stage. So it is limited. But, having to spend money on effective vibration elimination would bother me. I would prefer spending the money on a better phono stage that was not so effected. 
The cabinet my system is in is also extremely rigid, more so than anything you can purchase. My system is immensely powerful using a total of 4000 watts, two 8 foot ESLs and four 12" subwoofers (soon to be 8) and the only device I feel the need to isolate is the turntable which comes so equipped. As I previously mentioned I can put the phono stage and turntable right on top of a subwoofer with no ill effect I can hear. You never want to trust what anybody "hears" and I certainly can not say this applies to every phono stage or preamp as I have only tested one. 
However, If lewm and atmasphere insist there are electronics so effected I am sure this is true. But, If the military can make electronics that are immune to vibration so can the high end audio industry. As far as I can tell none of the electronics I have excepting the turntable are sensitive to air bourn vibration. In the cabinet they are in structural vibration is not an issue. Maybe people should spend the money on a solid cabinet instead of isolation devices. 
@melm , I never have to change my balls. Perhaps you need a turntable that has no balls, something like one of those Audio Technica direct drive tables:-)

I found the easiest fix for my customers was a wall mounted shelf (like the one from Project) on a load bearing wall. Worked every time. Hopefully there’s such a wall behind where you have your equipment set up!

I questioned the need for a SRA platform on my preamp and was assured by several that it was absolutely necessary. And when I asked if I also needed Stillpoints, I was definitively told that using them also would defeat the function of the platform. That it was designed for the stock rubber feet.
SRA has a military division which makes, among other things, vibration treatment for nuclear submarines. Thus, the Ohio and Virginia Class names for their platforms.
And about my preamp, if an electron microscope uses a vibration devise, why not a preamp?

Slab of PU foam or SorboThane between a cookie flagstones or marble pastry slabs 

Couple^^^