Thiel Owners

bworks

Welcome! Good to see you here. Reading through this thread, you will find several owners of 3.6 loudspeakers. We have a few fans of Bryston gear as well. What other gear rounds out your system?
I look forward in reading more about musical tastes.

Happy Listening!

Since namifan asked about screws, I'll peek into the rabbit hole with you.My EMI scans show that the steel screws are active in the driver fields. Early hypothesis is that they matter. I have replaced all screws in my working prototypes with brass. Fiberglas would be better, but unavailable in small quantities at affordable prices. I invite any of you to swap your screws for brass and post what you learn.

Starting with a pair of Dunlavy SC4s back in the 90's I have replaced all the steel fasteners with brass in all my electronics and speakers. Steel will bend the flux field of the electronic path. Easily heard on a circuit board stand off and its fastener.
Back plates that hold speaker lugs should also be non ferrous and their perimeter steel mounting screws should go away. Steel screws that hold down crossover boards should be gone. All the drivers will improve sonically with brass and not steel. Finding and then mounting with brass is somewhat difficult and time consuming..Start with the crossover and then move on to the tweeter. McMaster Carr is a great place to shop for brass fasteners including metric sizes mostly used around tweeters. Brass reduces interfering energy compared to steel in any audio part I have encountered. Tom

@tomthiel - 

I emailed Rob and he was kind enough to put screws in the mail to me.  I'd be interested in trying brass - just want to be wary of stripping the material the screws go into.

Tom - your missive runs parallel to my experience. In the case of my outboard crossovers, and mounting my internal crossovers and back-plates - I am using all nylon. Drivers need more strength so I use brass.

naimfan - stripping is an issue with screws directly into MDF. I use "Wood Hardener" from Minwax available at the hardware store, or you can use thin super glue dribbled into the hole since the internal threads are already formed via previous screws.
Take care with brass screws; they're not as strong as steel.