Can AVR DC Output at Preamp Outs be Increased?

+1 kijanki! 

vinyl_rules

Can the DC voltage output at a typical AVR be increased from a specified 1.0V output to 10V or more output Volts?

Ideally, you want your DC voltage at the output to be as close to 0 VDC as you can get.

I am confused by the lack of comprehension regarding my question.

1. jasonbourne52, my question said NOTHING about speaker outputs or the number of channels in my AVR. And FYI, voltage DOES NOT “drive” speakers, watts drive speakers. Watts = amps TIMES volts; volts = watts DIVIDED by amps.

2. kinjaki, to state “Your power amp can handle 0.75V or 2.5V at the input” is incorrect. I presume you meant to state my power amp is RATED at 0.75V or 2.5V at the input.

3. creeds, why would I want 0 Volts DC at my output? 0 Volts DC at a PREAMP output renders it incapable of driving an external power amplifier.

To reiterate, my question my question involved increasing the voltage output at my AVR’S PREAMP outputs. As previously stated, “I wish to increase the PREAMP output of my AVR from 1.0V RMS to at least 10V RMS at all PREAMP outputs.”

vinyl_rules

I am confused by the lack of comprehension regarding my question. ... why would I want 0 Volts DC at my output? ...

You want as little  DC voltage on your preamp output as possible.

As previously stated, “I wish to increase the PREAMP output of my AVR from 1.0V RMS to at least 10V RMS at all PREAMP outputs.”

As has been explained to you, there's no advantage to doing this and  you'll likely overload your amplifier input if you do.