Integrated/Power Amp for Vienna Acoustics Mahler


My current system consists of a Teac VRDS-25 CD player with a superclock used only as a transport (and a streamer) into a Weiss DAC 202. The Weiss feeds a BAT VK40 preamp modified with Mundorf SilverOil coupling caps. The powers amps are DIY Hypex Ncore NC400 based monoblocks feeding the Vienna Acoustics Mahlers speakers with upgraded crossover components. There is no analogue front end. I mainly listen to rock, progressive metal/symphonic metal and a little opera.

The system sounds good but I feel the highs are little harsh, perhaps even thin with perhaps a hint of sibilance which I think could be associated with the Class D amplification. I am therefore thinking of either upgrading the monoblocks or replace the preamp and the power amps with a quality integrated. Valves are out, the Mahlers while are relatively efficient, present a difficult load dropping to below 3 Ohms at some frequencies bellow 100Hz, IMO they need loads of current to drive them properly.

I am considering the following integrated amps:
  •  Gryphon Diablo ( the original, NOT the 3000) / Diablo120
  •  T+A PA3000HV
  •  ASR Emitter II (Exclusive) 
  •  Vitus RI-100
  •  Audio Flight FLS10 
  • Audio Analogue Maestro Anniversary
  •  Audionet Watt?

Alternatively I keep the BAT preamp and I look for a power amp:
  •  Old secondhand Gryphon Antileon (perhaps Signature, not the EVO)
  •  Burmester 956 MKII
  •  Linnenberg Liszt
  •  Kinki Studio EX-P7

I am based in Europe, all of the above are within my budget (mostly secondhand), I could stretch my budget for something exceptional. Unfortunately there is no way I could audition any of it where I live so it is going to be a blind buy...
Anything else to consider? Any thoughts?

Thanks!

greg_f
@greg_f  I am very pleased with AHB2. IMO, amplifier should be wire + gain. If you want even order harmonics, there's always EQ ;). I ended up buying two AHB2s. Have you tried the tweeter attenuation switch on the Mahler? How about room treatments? Both may be cheaper than buying a new amp...
@csarcone

Good to hear you are satisfied with the AHB2. So you are running them in bridged mode? Why did you feel the need to add a second one?

Yes, I have tried the tweeter attenuation but didn't 'cure' my issue. I am moving to a new house with a dedicated music room which will be measured and then acoustically treated. As for EQ, I haven't mentioned that there is a Trinnov ST2 Hifi between the digital transport and the DAC used in the digital domain to provide room correction. The point is I am trying to get as good as possible sound before I apply room correction, which of course brings its own problems.

@greg_f I bought the second AHB2 to power my VA Maestro center. I'm only running that amp in bridged mono. The Mahlers are powered off a single AHB2 in stereo. The stereo setup is plenty loud for my room without amp clipping.