Cube Audio Nenuphar Single Driver Speaker (10 inch) TQWT Enclosure


Cube Audio (Poland) designs single drivers and single driver speakers. 

Principals are Grzegorz Rulka and Marek Kostrzyński.

Link to the Cube Audio Nenuphar (with F10 Neo driver) speaker page: 

https://www.cubeaudio.eu/cube-audio-nenuphar

Link to 6Moons review by Srajan Ebaen (August 2018):

https://6moons.com/audioreview_articles/cubeaudio2/

----------------------------------------

Parameters (from Cube Audio):

Power: 40 W

Efficiency: 92 dB

Frequency response: 30Hz - 18kHz ( 6db)*

Dimensions: 30 x 50 x 105 cm

Weight: 40 Kg


* Frequency response may vary and depends on room size and accompanying electronic equipment.
david_ten
Thanks david_ten, toetapaudio, charles1dad and cal3713.

I know the more expensive Allnic separates use point to point wiring but the integrated amps use a PCB.

There's an image of the inside of a T2000. 

https://www.stereonet.com/forums/uploads/monthly_2018_10/L9740204.thumb.JPG.cba63850ad0d73ed4e7a1eee...

KS Park told me that the T1500 also uses a PCB, so probably very similar.

I've been using an Allnic T2000 which uses 4x KT120 tubes at 50-100W (Pentode/Triode) which was OK but I think was maybe too powerful and has maybe been damping things a little.

I've been trying (just as an experiment) my old SS Olive Naim Nait 2 20w which doesn't actually do a bad job.

I know purity of signal path is very important with tube amps.
I suspect that the internal environment of the T1500 is less crowed with fewer parts as SET is simpler. Higher power push pull amplifier will have a higher parts count.
Charles 
@yorkshireman You are welcome. If you are still considering options...please know that I’m not trying to dissuade you from the Allnic T1500...here are a couple of avenues that may be worth exploring.

Audion Audio’s (UK; with France based office) Silver Night integrated line. Their entry level utilizes a PCB, but are point to point hardwired above that level. Known for their 300B version. Used upper levels units may be within your budget.

If you want to specify the build and parts, then look into Ken Uesugi of Sound Gate / Otomon Laboratory (Japan). Vintage chassis / looks, if that’s okay with you. He sometimes lists on Audiogon. He should be able to deliver within your budget.

And a +1 to @cal3713 ’s post.