Is anyone thinking about building Walsh drivers?

Westborn - I won't argue taste with you, but have you heard the current models in the Ohm Walsh line? I had never heard Ohm Walsh speakers prior to my home trial of the 2000s, so my only comparison was to other brands of speakers. IME, the 2000s compete extremely well in and a good bit above their price point. John Strohbeen has refined his products, and, obviously since I bought them, I find them to be among the best speakers out there. Of course, YMMV, but if you value warmth, detail, large soundstages, well-defined imaging, accurate timbre, and clean extension at both ends, you might be surprised by the current Ohm line.

OF course any good speaker including omnis and the newer OHMs can sound mediocre if not set up well. Personal tastes aside, the same speakers can sound absolute top notch if set up optimally.

Like most things, it all depends...

Also worth mentioning that Dale Harder's website has perhaps the most information I have seen anywhere regarding what goes into creating a quality Walsh driver. Pretty daunting....

Westborn, your not alone. The link to Dae Harder's site is worth checking out, as are the archives here on Audiogon.

I have been giving a lot of thought to this. I helped build the prototypes for the Walsh tweeter that Infinity used back in the '70's. If the cone was silver with a diamond "crosshatch" pattern (very early models) it was probably built on my kitchen table. That material was Reynolds "Diamond" aluminum foil that is probably no longer available. It was supported by 1 or so mil acetate, which thinking back was a bad idea.
I've started a thread on the DIY Audio forum to share my work towards building a semi-full range driver. I'm starting with the tweeter, since it is somewhat familiar territory, and a lot of folks out there have the old Infinity's who would like to get them working again.
Like the ill-fated Ohms, the materials used by Infinity to dampen the cones and terminate the traveling wave was very finite in it's useful life. Newer materials may offer better longevity.
Obviously it's going to take a lot of trial and error, but ultimately I'd like to think I can get something like the German Physik drivers for a lot less than 50 grand a pair.
J-

Glo,

Sounds like a rational plan.

I suspect many who are fond of the older generation (near) full range Walsh drivers and wide range DDDs in particular tend to be enamored more so with the Walsh driver top end sound.

The newer OHM CLS drivers take the opposite approach, using a conventional tweeter/super-tweeter crossed over to the Walsh driver at as high afrequency as possible, at ~ 7-8 Khz AS I recall.

I gotta say though that I find it hard to understand how anyone could not be impressed with the overall smoothness and detail including the top end that at least the newer OHM CLSs are capable of delivering. I say capable in that I find the limits so far depends on what's upstream more so than the speaker itself. I have heard major differences from absolute top notch to just so/so depending on the specifics of whats upstream feeding my OHM series 3 CLS speakers. The ARC tube amp with teh newer and pricey West German 12AX7 tubes ARC now is providing, the carefully matched BEl Canto Class D amps, and either somewhat humble phono or digital sources I use currently are in that top notch class IMH and also maybe somewhat biased opinion.

If you do it successfully for modest cost, maybe approach John Strohbeen to see if the Walsh tweeter might be utilized in the 2-driver CLS configuration maybe? That might be interesting!