Kimber PK 10/14 Ascent Power Cord


Has anyone used both the PK 10 and 14?  If so, (assuming the same connector metals) did you notice whether the 14 was better on sources than the 10 - or whether both were basically the same? 

Also, any comments on the Rhodium vs. Gold connectors would be welcome.
maxima95
Cables pretty simple heavy amp sucking gear the heavier cable (10), lighter gear, like SACD or DAC or Preamps a 14 or 16. Personally I like weaves 16 to 24 conductor.. VERY quiet very dynamic cables.

Terminal ends.

Gold clad over copper, but never rhodium. Make sure they are not made of brass or just about anything under the sun, THEN electroplate it with very thin gold or rhodium (way to hard)

As for the best terminal material;

1. 5-7n .99+ pure(r) silver
2. red copper with silver clad
3. silver or copper with gold plate
4. red copper, or yellow copper
5. nickel over copper/red/yellow
6. anything
7. rhodium (WAY TO HARD) under water in Alaska. Good place for rhodium.

Regards
Post removed 
Thank you for the information.  

I have not tried a PK 14 Ascent and was curious.  I only use 10 ga cables or above anyway.  And yes, the price difference isn't significant.

I have tried both the Gold and Rhodium PK 10 Ascent on a Class D power amp.  While I found the Rhodium to have the typical signature, fortunately I did not find it to be edgy - just a bit cool.

Thanks again.