2. cables
  3. 168632-130690

Should I try XLR?

I've never tried XLR cables, just regular ICs with my components. I currently have a Luxman 505UXii integrated with Dynaudio Special 40s. My CDP/streamer is a Marantz ND8006. I'm currently using WyWires ICs with all of my equipment. Would adding XLR cables to the CDP/streamer make a huge difference---if so, should I stick with WyWires XLR or something else? Thanks in advance for your help. 
bluorion
oldhvymec
5,101 posts
 
I'm kinda stumped too, where do you want to use the XLRs at?

Is there a noise issue? No Noise, No problem...

 Good connection though. I use XLR on all power amps that have them..

Regards
mike_in_nc
1,156 posts
 
Balanced (XLR) cables add value only if the components on both ends support them. In that case, they offer better connectors, less chance of potentially catastrophic hum from touching a live cable end, greater resistance to EMI/RFI, and less likelihood of ground loops.
bluorion OP
477 posts
 
@lalitk Thanks for checking into ND8006--well, that solves that.  I should have looked into that myself. If I decide to 'tweak' or upgrade late, I'll try XLR. 
ryder
1,690 posts
 
I'm not sure about the 505uxii but XLR cables on my 590AXII made a rather significant difference in comparison to single-ended in my system. Balanced connection between the amp and DAC.
deadhead1000's avatar
deadhead1000
714 posts
 
@ryder I own the 590 also and switched to XLR’s to my DAC. The main reason I did so as I have little room between cables behind my equipment and felt the added isolation might help. It did. 
More to discover