Cable Goop Review George is going to freak!!

theaudiotweak,
Are you buying the stuff by the gallon?

ozzy

The results I have experienced are with a lite coat..not dark not like boot polish. I take the supplied brush and put a drop or 2 on copper foil and then use a artist brush to apply to the parts at hand.
This gives me greater control.
I used the same method with TC.
I also used the supplied stiff narrow fine brush on my dac ribbon cables and those on the transport.  Tom

Sounds interesting. I must say that I bought the 3ml bottle and have done my whole system and I think I have more than 1/2 bottle left!
So it does go a long way.

ozzy

I bought a second small bottle in case I run out mid course. I did use some to give a couple friends a taste of amazement..and they were. Tom

@Johanvz

I used it on 2A3 pins and small signal pins. It made a huge difference.

Have you looked into how to clean the tube sockets if you don't want to not use it anymore? 

Also, what would you do when you tube roll? Apply only to new tubes or re apply even when going back to one you used before?

Thanks
Pauly