So, the stock footers on the LSA are sorbothane? How do you know they are sorbothane and not some other type of rubber footer? All soft things are bad...so no matter. Just curious. I cannot imagine putting soft rubberish feet on anything. I included some rubberish footers with my EVS1200 amp but the below was in the instructions:
"The 4 feet should be installed underneath the amp before listening. These feet are made by EAR and are used by Audio Research and others but are not anything special. If you have other feet, please try them. I am currently testing other better feet (Ginko, Teo, Ceraballs, Mad Scientist, etc.) and will have information on my website about footers and mounting platforms. The stock feet are OK to start listening but this amp deserves some mucho better footers."
Everything makes a difference. Please experiment. Still loving the best Mad Scientist footers.....on top of 1.5 inch maple.....on top of bamboo cutting board from IKea......on top of tractor tire innertube with hardly any air in it. I have tried some very low frequency tuned springs underneath instead of the air bladder and it was essentially the same (excellent).
"The 4 feet should be installed underneath the amp before listening. These feet are made by EAR and are used by Audio Research and others but are not anything special. If you have other feet, please try them. I am currently testing other better feet (Ginko, Teo, Ceraballs, Mad Scientist, etc.) and will have information on my website about footers and mounting platforms. The stock feet are OK to start listening but this amp deserves some mucho better footers."
Everything makes a difference. Please experiment. Still loving the best Mad Scientist footers.....on top of 1.5 inch maple.....on top of bamboo cutting board from IKea......on top of tractor tire innertube with hardly any air in it. I have tried some very low frequency tuned springs underneath instead of the air bladder and it was essentially the same (excellent).