If anyone has a more extensively tweaked panel than mine I would like to see it. The panel was taken down to the bus bars, cleaned, treated and reassembled. The entire panel, every contact surface is treated with Total Contact. There's a Gate, Mats, and more. Yet even I am not nuts enough to mess around with what you are asking. That is so far down the list of things that would be audible improvement it literally is not even on the list!
Arrange circuit breakers in panel
Hello
I've been following the discussions on this forum for many years, first time I've posed a question. I am in the process of adding two more dedicated lines to my rig. I was wondering, has there been a consensus on the best location, within the main service panel, of the placement of the audio/video breakers? I realize load balancing will dictate space used, but I've read that folks will place double pole breakers at the top of panel (in my case Square D QO 200 amp main panel) and some prefer single pole breakers toward the top. Has anyone experimented, come up with a better arrangement of the breakers? As long as I have the panel open, thought I might try to squeak a little more SQ out of the rig. Thanks.
I've been following the discussions on this forum for many years, first time I've posed a question. I am in the process of adding two more dedicated lines to my rig. I was wondering, has there been a consensus on the best location, within the main service panel, of the placement of the audio/video breakers? I realize load balancing will dictate space used, but I've read that folks will place double pole breakers at the top of panel (in my case Square D QO 200 amp main panel) and some prefer single pole breakers toward the top. Has anyone experimented, come up with a better arrangement of the breakers? As long as I have the panel open, thought I might try to squeak a little more SQ out of the rig. Thanks.
- ...
- 14 posts total
| Post removed |
- 14 posts total