2. analog
  3. 169608-509

What angle should I set the VTA on my VPI turntable?

I can't believe after all these years, I am asking such a basic "analogue 101" question, but here it goes. I own a VPI turntable that has a "VTA on the fly" knob.  I thought the best VTA setting was for the arm to be 100% parallel to the record surface.  

However, based on some research, I am not so sure that is correct way to set the arm to achieve optimal VTA and correlatively, optimal SRA.  Not sure, ... but I think I have to raise the pivot side of the arm.

Any advice would be appreciated. 

Thanks.     
bifwynne
wlutke
744 posts
 
cleeds,
If you raise the "tail" (pivot) you can only increase VTA.
I know. Show me where I said differently.

Increasing VTA by raising the "tail" (pivot) will also increase VTF.
Wrong. Again, it changes the balance and the VTF lightens.
As an example, visualize the arm at level neutral balance above the platter. Raise the platter until it contacts the stylus. Still 0 grams pressure. Lower the tail. Now you have pressure. You’ve LOWERED the tail, INCREASING the pressure. There’s your physics.
lewm
13,842 posts
 
Dear lutke, I don’t know about your model, but throw it out. Now think that you and a friend are carrying a sofa. On level ground, the burden is equally shared. Now you have to carry the sofa up a staircase. Who is working harder? The guy at the top end or the guy at the bottom end? Raising the pivot point shifts the center of gravity toward the stylus. VTF goes up.
wlutke
744 posts
 
lewm,
Rest the stylus on the platter at 0 grams. Lower the pivot point. I guarantee the pressure will increase. Raise the pivot point and it will loose contact with the platter. VTF is set with the scale at record level because setting above the record height (tail down) will give a false heavy reading up to .25 gm. on some scales.
lewm
13,842 posts
 
Your model is flawed.
wlutke
744 posts
 
I've done the work, taken the measurements.  Nuh-uh is not a rebuttal.  Show me.
More to discover