Cable Goop Review George is going to freak!!

Sober reader and retainer of printed information on this website and others. Tom

I treated the analog side of my system.  I have been progressively treating the connections in my stereo system with the NPS-1260.  It is a very tiny bottle but seems to go a long way.  I treated the pins of the phono cartridge, the DIN connector and RCA's of my phono cable.  I immediately noted increased clarity and space in the sound stage.  Then after 5 days I treated the two circuit breakers and receptacles of my dedicated power circuits.  I didn't expect much from that but to my surprise the bass was clearer and tighter.  I played my Stanley Clark CD which has gobs of bass.  I know the first track very well because I have been using that track for months to improve my room setup for bass response.  I heard improvement in the bass playing that CD.  So in a couple of weeks I will play that track again to look for any changes.  Overall, this stuff does some good.  The most noticeable changes to me were the first application to the speaker cables on the amp side, then the phono cables and then the power lines.  Adding the AQ Niagara Power Conditioner had a much bigger impact, of course.  The NPS-1260 could be akin to changing out cables with the exception of the 20 amp circuits and the phono cartridge.  I'm planning to treat the pins on all of my vacuum tubes next.  It's a lot of work- wah wah...

Just treated my new MC O5s Helix Plus Signature with the 1260. And I am hearing better sound across the board . I have had the MC O5s Helix Plus signature in my system before and with the 1260 treatment the sound is better than with out.

Has anyone re-applied the NPS-1260 due to removing and re-connecting cables a few time (like when one rotates equipment, like amps, dac's, speakers and the like)?  If so- what did you notice and was the effect the same or different as applying the first time?

The NPS1260 doesn’t actually come off when the fitting is disconnected, etc. Many times, all that is necessary is to just use a small brush to redistribute it on the fitting.

To answer the question, no, I have not noticed a change when reapplied.

ozzy