Describe ube sound vs solid state


What are the charesterics in comparing each of these?
nyaudio98
I feel that you can get a nice sounding, powerful solid state amp in the $1,000-$1,200 range (used) where you would have to spend double that to get an equally well built tube amp.

I really enjoyed my Classe CA-200, and I also like the Parasound Halo A21, McCormacks and Conrad Johnson amps.

My Primaluna Prologue 3 was nice but felt more like an entry level tube amplifier and not as highup the chain as my Classe CA-200. The Primaluna also ran out of steam at about 80% of the volume I wanted. It also couldn't control the bass like a hefty solid state amp.

Tube amps can require more maintenance and swapping tubes can get expensive. My Primaluna popped and blew smoke one day while just being turned on.

Also, I like to leave my equipment on 24/7 so I don't have to wait 10-20 minutes for itto warm up and sound its best; you can't leave a tube amp on constantly.

Many people say solid state amp, tube pre amp is the way to go but I have never tried this set up.

Tubes look sexy though, and they can impart a certain richness and texture to the music which can make it sound a bit more organic, but at the same time, a good solid state amp can sound rich and full bodied also.
ube sound like this: ~~~~~~~~~~~~~~~~~~~~~~

whereas solid state sounds like this: ``````````````````````````

I don't think you will get a better explanation than that.

Cheers,
John
Tube, better midrange, Solid State, better bass. Ube falls somewhere in between.
Imagine you were dead and they were piping down music from a music server only you thought you were dreaming and the music didn't make any sense since it didn't sound like real music you remembered when you were alive. That's what Solid State Amps sound like.