Audiophile grade ground rod is easy. Wait till you go looking for audiophile grade ground to drive it into!
- ...
- 35 posts total
Here you go. Solid copper ground rod. https://www.gordonelectricsupply.com/p/Erico-Lpc711-Cu-Solid-Ground-Rod/6315842?text=ERICO+LPC711++c... I recommend at least two rods. Silver plated solid copper bare wire. https://www.ganpatiengineering.com/bare-silver-plated-copper-wire.html |
I’m wondering what true audiophile rod made from OCC copper would cost and would it provide better sonic,s . I bet it would ,It wouldn’t do a darn thing... The earth does not possess some magical mystical power that sucks nasties from audio equipment. Grounding Myths "Electromagnetic Compatibility Engineering" by Henry Ott 3.1.7 Grounding Myths More myths exist relating to the field of grounding than any other area of electrical engineering. The more common of these are as follows: 1. The earth is a low-impedance path for ground current. False, the impedance of the earth is orders of magnitude greater than the impedance of a copper conductor. 2. The earth is an equipotential. False, this is clearly not true by the result of (1 above). 3. The impedance of a conductor is determined by its resistance. False, what happened to the concept of inductive reactance? 4. To operate with low noise, a circuit or system must be connected to an earth ground. False, because airplanes, satellites, cars and battery powered laptop computers all operate fine without a ground connection. As a matter of fact, an earth ground is more likely to be the cause of noise problems. More electronic system noise problems are resolved by removing (or isolating) a circuit from earth ground than by connecting it to earth ground. 5. To reduce noise, an electronic system should be connected to a separate “quiet ground” by using a separate, isolated ground rod. False, in addition to being untrue, this approach is dangerous and violates the requirements of the NEC (electrical code/rules). 6. An earth ground is unidirectional, with current only flowing into the ground. False, because current must flow in loops, any current that flows into the ground must also flow out of the ground somewhere else. 7. An isolated AC power receptacle is not grounded. False, the term “isolated” refers only to the method by which a receptacle is grounded, not if it is grounded. 8. A system designer can name ground conductors by the type of the current that they should carry (i.e., signal, power, lightning, digital, analog, quiet, noisy, etc.), and the electrons will comply and only flow in the appropriately designated conductors. Obviously false." Henry W. Ott Who is Henry Ott? http://www.hottconsultants.com/bio.html . |
- 35 posts total