Nobsound springs - load range

@ryder

I gotcha, nice Lux. Yes, your layout is a bit different as it is an integrated, not a stand-alone amp. The shots of mine are on my virtual system page. I use the Nobsound feet under the chassis itself, not to its stock feet, but instead, adjacent to them. I should probably remove the stock feet actually.

I had been using cones prior, which did make a significant difference. The Nobsound vs the cones I was using is pretty much the same/similar actually. Perhaps a little better, but not anything that ‘turned my head’ over.

Or I can just set my entire system on a set of box springs.🤣

 I do like the idea of damping the springs. Thinking that a coat of rubberized paint that the spring can be dipped in. I know, I think too much.

No I sprayed 50 springs with Flex Seal and then used ear plugs inside the springs. It made quit a bit of difference.. It actually works perfect for lighter stuff like turntables, amps.. Speakers I notice it a lot less. The springs do it for the speakers alone. I load some gear with springs and a block of wood on top too. I load it in a slot between 2 3/4" pieces of 13 ply birch. Tinkering..

Regards

@ryder The springs under your Luxman are too compressed. 

A quick way to damp the Nobsound is to wrap 1 turn of PTFE plumber's tape around the outside of the space between the plates touching all the outer springs.