Comparing Speaker Cables


I have accumulated several pairs of speaker cables that I have never tried to do careful A/B comparisons of because the time it takes to swap them is longer than my audio memory. But my speakers are bi-wired and it occurred to me that I could hook two different cables up and then only swap them at the amp which would be much faster. Is there any sonic downside to having a pair of unconnected cables hanging off one of the sets of inputs while the second set is connected to the amp?

pinwa

Actually Kimber cable doesn't make the best speaker wire it's just junkie ofc wire, the best wire for sound is OCC single crystal wire and that's been proven for over 40 years now

I just did a similar test by connecting sets of cables to A and B outputs and then to the speakers without removing jumpers. I am able to just flip the switch on the amp from A to B and back in real time and not disconnect and reconnect the cables.

 

Cables are 14 foot pair of Synergistic Research Resolution Reference and a 5 foot pair of Kimber 4VS doubled to make them 8VS. I have been using the SRs for many years since getting them with a complete system in 2008 that I purchased. I got the Kimbers from same person when he gifted me a pair of Rogers speakers and the Kimber was in a Bi-Wire configuration.

 

Honestly, hearing much of a difference is really really hard but I feel the SRs have a slightly larger and airy presentation while the Kimber is more just solid and clinical. I am still playing with different music but will probably stick with the SRs when all is done. But there is not a thing wrong with the Kimbers if that was all I had to use.

Pinwa…

You’ve some decent information with which to move forward with. Sort of skip over the typical Chip eating lard bucket god of cheap Products and crazy ideas you’ll be fine. Pretend it’s not there it’ll get old and fizzle out.

Cheers to all…. More chips to….

For sure the amount of difference you hear also depends on your expectations and your definition of small/big difference. Assuming your system is capable of good level of detail, then different cables should add their specific sound signature. I have 4 pairs of cables and I could never make a mistake which one is on duty. Friends also usually notice if I have changed cables just by listening to the system and not being aware of the change.

I to have four pair of speaker cables and when I bought the KEF Reference 5’s, I tried all of them for a couple of days each and then picked the pair I liked the best. About seven weeks later, I did it again and I picked the same pair. I plan on doing it one more time and then getting rid of two of the sets I don’t use anymore.

JD