REL B3 connecting to Linn Klimax Solo help...

Hi Al Does this help?

Klimax power amps have RCA shield connected to circuit ground which is lightly (~100R) connected to chassis.

The KDS (the source I used with the earth plug on the rear has transformer coupled outputs, so RCA shield is floating.

I still believe the unit is faulty because the gain at 50% shouldnt cause that sound I hear. Im taking it in this morning to get fully checked before I go further.

I think the chassis screw was indeed working and that the gain needed to be pushed more but couldnt because of a fault...

Cheers

Klimax power amps have RCA shield connected to circuit ground which is lightly (~100R) connected to chassis.

That is good background info to have, but it is not directly relevant at this point. Corresponding info about the preamp would definitely be helpful, though.

The KDS (the source I used with the earth plug on the rear has transformer coupled outputs, so RCA shield is floating.

That is definitely relevant, as it most likely means that the circuit ground of the source is isolated by the transformer from the circuit grounds of the preamp and power amp. Which would absolutely mean that the ground point on the source should NOT be used as the ground point of the sub's input. If that were done it would mean that the return path to the amp taken by current provided by the amp to the sub (remember that current needs a complete circuit to flow) would be mainly via the AC safety grounds of the components + the safety ground connections in the power wiring + whatever impedance connects the circuit grounds and chassis of the components. Definitely not a recipe for good results.

Im taking it in this morning to get fully checked before I go further.

OK. Good luck!

Regards,
-- Al

At the shop now, we'll see what the story is. New cable is on its way! Ill report back with the results

Thanks for your help Al! :)

Update on this.

The cable is still making its way to me... but the repairer has found the driver is faulty. The magnet had dislodged itself from the unit... Thats what was making the horrible noise.

A replacement driver is funnily enough, in stock..

Soldered a RCA onto the Black wire as per your suggestion Almarg and the driver was replaced. All working nicely now ;) Thanks!!