The whole issue of using coax on a Node2/Pontus ll combination is confusing. Why are some having problems and others not?
Denefrips Pontus "burn in" period?
Hello all
Now there's a chance I may be a little premature with this, but I've received my Pontus 8 days ago and have had it running ever since, powered up, most of the time with signal going through it, and so far I'm a little concerned. I am aware that with this particular dac it is recommended to run it roughly 10 days before it really burns in, but being only a couple of days away, I can't say the sound has changed very noticeably. Matter of fact, when I A/B with my project S2 plus dac, and even my blue sound node internal deck, I can barely tell a difference! Does burning happen gradually? Is there all of a sudden a hallelujah moment where this thing starts kicking ass? Does anybody have more experience with this particular piece of gear? Current system is rogue audio ST100 amp, rogadio RP1 preamp, upgraded tubes, blue jean cabling, upgraded power cords on power amp and preamp. I had high hopes that this dac that has received so much high praise was going to blow my meager dacs out of the water, and so far not the case at all. I must say, the thing weighs a ton and looks gorgeous, but I'm getting a little concerned at this point that I may end up disappointed. Talk me off the ledge!
- ...
- 67 posts total
In my case, the Node 2i and coax connection problem was not limited to a specific DAC. I tried 5 DACs with the Node, and in each case coax was the limiting factor. Toslink was maybe marginally better. IMO, the Bluesound Node is a good starter streamer with a below par DAC, but even as a streamer I feel that it can limit the potential of your DAC. I know it won't sit well with the 'all streamers are the same' crowd but I'm just sharing my experience. Disclaimer: I had the prior version of the Node 2i (the one without USB out). It is quite possible that the new model has overcome some of the limitations in terms of SQ. |
The coax cable is 2 ft long Canare by blue jean cables. @mr_m exactly. Is this a weakness of the node, the pontus, random, that's what I'm trying to figure out. I've sent out an email to Vinshine. It would be nice to know what this means for my streamer going forward, do I have to move it to my b system and upgrade it or should I be content with just using a USB. Do I have a faulty unit? Did it not burn in long enough? |
@arafiq I have the new node, and the USB most certainly made a difference. The toslink I had laying around, which was a 3 ft radio shack cheapy, like you said sounded possibly marginally better but not anywhere near the USB. Trying to figure out if this is a weakness of the node or the Pontus itself. Judging by what you're saying most likely it's the blue sound, I have no doubts that the Pontus is a well-built quality piece of gear. |
- 67 posts total