Experiencing speaker imbalance, while amp headphone output is fine. Any ideas?


Hi all. Purchased a brand new Audio Research i/50 integrated amp a few weeks ago. Sounded fantastic straight out of the box. Left town for a week, came back and the left channel is now sounding substantially louder than the right. I have Vandersteen VLR CT’s paired with it.

The amp also has a built-in headphone amp. I’ve checked that, and the L/R balance is perfect.

Does anyone have a clue here what could be happening?

Thanks so much for everyone’s time.

128x128gnarmite

Not familiar with that particular ARC amp, if it is new from a dealer then you can get a warranty replacement tube from ARC, assuming it is a tube issue. If you discover it is a tube, call ARC they will send you out a new one. Maybe even a new full set.

It sounds like you burned in the tubes and found a dud.

Thanks. I hoped that ARC's factory burn-in test would have ID'd the bad apples before shipping, but I won't be too unhappy if the issue is as simple as a bad tube.

if it is new from a dealer then you can get a warranty replacement tube from ARC, assuming it is a tube issue. If you discover it is a tube, call ARC they will send you out a new one. Maybe even a new full set.

Yep, brand new. Thank you for this info. Will lug it to my dealer to suss out asap.

 

OP did you keep the old tubes? Usually 24-48 hours after they have been moved or shipped. That is usually the deal. So they get burned in and then they are shipped and placed in service. Usually after 48 hours they are ready for normal service. Shipping and moving is a valve killer..

Take a pencil and tap the tubes with the volume down.. You might be surprised.

R&R the new one with an old one UNTILL you  get the new valve. Or XChange the set.. 5 minutes I'm up and running with my amps. Mac, Cary, VTL, DIY

Regards

OP did you keep the old tubes? Usually 24-48 hours after they have been moved or shipped. That is usually the deal. So they get burned in and then they are shipped and placed in service. Usually after 48 hours they are ready for normal service. Shipping and moving is a valve killer..

Take a pencil and tap the tubes with the volume down.. You might be surprised.

R&R the new one with an old one UNTILL you  get the new valve. Or XChange the set..

Thanks. So, it's a brand spanking new amp with new tubes aside from my 3 weeks of use (and it sounded great for the first 2 - 2.5 weeks!). I just tried swapping pre-amp tubes with each other and now my L/R balance is WAY better. R now just slightly louder than L, whereas before this swap, L was FAR louder than R. It was a 10db difference at my usual listening level.