2. cables
  3. 174809-168306

Ethernet patch panel and network switch question

Guys,

I have an ethernet patch panel in my office that I'm running ethernet to my Antipodes K40 music server.  I've been reading a lot about the NA EVO ethernet passive filter and am on the verge of pulling the trigger.  However, it seems that everyone recommends a network switch from the router.  My router is 2 floors down into the basement.  Do I need to run a switch from the patch panel on the wall to the ENO and then to the K40?  Do I need a switch at all?  TBH, I have no idea what the switch would do.  I'm asking b/c lots of folks are talking about the benefits of using a switch before the ENO.  Thanks.


Bill

wtb
wtb OP
35 posts
 

Our building was constructed in 1790 and later added onto in the late 1960s.  Quite attrative.  It was later bought and completely rehabbed by someone a few years prior to me purchasing the building.  They made the unfortunate error of foaming the entire building for insulation and failed to run any conduit to encapsulate LAN wiring.  ALL electrical and networking wires are foamed in place.  This has caused problems for us as we can't upgrade anything.  We can't fish a line b/c everything is hard foam insulated.  It's the only downside of owning this building.  So, that in a nutshell is why I can't run a LAN from downstairs in the basement where our network is located, to my personal office on the 2nd floor.  It's been an issue since I bought the building last year and we still haven't found an acceptable work around.

 

Bill

lalitk's avatar
lalitk
5,454 posts
 

@wtb

Network Acoustics ENO comes with a 30 days money back guarantee. The only way for you to know if adding a ENO provides audible improvements between patch panel and K40 is by trying it. If you don’t hear any audible improvements, send it back. Every system is unique so results from passive filters and switch greatly varies. I would suggest you to try ENO first and then approach the Ethernet switch upgrade. 

IME, fibre optic benefits are not fully realized unless your router and server (K40)  are optimized for optical network. 

wtb OP
35 posts
 

Thanks.  I'm going to give it a shot based on everything I've heard on Audiogon so far.  

 

Bill

david_ten
5,480 posts
 

+1

I'm going to give it a shot

david_ten
5,480 posts
 

Given your building’s history and restrictions....

It’s been an issue since I bought the building last year and we still haven’t found an acceptable work around. 

ALL electrical and networking wires are foamed in place.  This has caused problems for us as we can't upgrade anything.

 

Have you given thought to setting up a Mesh Network? It’s a solution for the audio side (and has broader application if you want it to).

Run a short length of ethernet cable from the Mesh Network Satellite to your K40.

The K40 was one of the options I was considering. It’s a great unit. I have a feeling it’s potential is being hobbled by your current setup.

You can still use the ENO filter after the Satellite, should you want to and should it add to overall performance.

More to discover