A bypass cap is just a smaller value cap that goes in parallel with a larger value to extend and purify the signal as large capacitors are inductive (therefore not as pure or as extended as a smaller cap). There is no cap in the Nenuphar. If you bypassed the driver (across the hot and negative) you would be adding a filter. A no no. What you want is to enhance the driver.....not diminish it. Ground Enhancer, Bybee thang....hard wiring to the voice coil wire, better wire, eliminating the rear binding posts......these enhance the speaker.
Cube Audio Nenuphar Single Driver Speaker (10 inch) TQWT Enclosure
Cube Audio (Poland) designs single drivers and single driver speakers.
Principals are Grzegorz Rulka and Marek Kostrzyński.
Link to the Cube Audio Nenuphar (with F10 Neo driver) speaker page:
https://www.cubeaudio.eu/cube-audio-nenuphar
Link to 6Moons review by Srajan Ebaen (August 2018):
https://6moons.com/audioreview_articles/cubeaudio2/
* Frequency response may vary and depends on room size and accompanying electronic equipment.
Principals are Grzegorz Rulka and Marek Kostrzyński.
Link to the Cube Audio Nenuphar (with F10 Neo driver) speaker page:
https://www.cubeaudio.eu/cube-audio-nenuphar
Link to 6Moons review by Srajan Ebaen (August 2018):
https://6moons.com/audioreview_articles/cubeaudio2/
----------------------------------------
Parameters (from Cube Audio):
Power: 40 W
Efficiency: 92 dB
Frequency response: 30Hz - 18kHz ( 6db)*
Dimensions: 30 x 50 x 105 cm
Weight: 40 Kg
* Frequency response may vary and depends on room size and accompanying electronic equipment.
- ...
- 1567 posts total
- 1567 posts total