I have an Arcam avr400 it has preamplifier outputs, also has audio connectors where do I plug in the wires from Bam? seems they're rca jacks, behind the Bam box is L/R input and output. any advice would be appreciated, I will eventually call Bobby!
thank you very much Swampwalker and Brf you have been very helpful, cd player to the bam input and output to the pre-amp, gona try that. thanks very much guys!!
Since you have a receiver (pre-amp, tuner, amp on one chassis), the BAM output is going to go to the CD input on the receiver, which directs it to the pre-amp section of the AVR and then the amp section. Assumming CD is your only source. For more than one source, insert it into the tape loop as Brf says, or insert btwn the pre-amp and amp section of the receiver, if there is a pre-out and a main amp in.
Swampwalker, I'm a little mixed up now, should I connect the bam "out" to the cd player or to the receiver's cd input? then from bam to receiver's preamp out? will I need more than two sets of rca jacks? any wires recommendation? thanks
For use w one source, connect output of your CD player to BAM input using RCA cables. Connect BAM output to CD input on the AVR using RCA cables. Select CD input on AVR and enjoy.
You must have a verified phone number and physical address in order to post in the Audiogon Forums. Please return to Audiogon.com and complete this step. If you have any questions please contact Support.
