I need help hooking up Merlin vsm mme Bam to avr

Since you have a receiver (pre-amp, tuner, amp on one chassis), the BAM output is going to go to the CD input on the receiver, which directs it to the pre-amp section of the AVR and then the amp section. Assumming CD is your only source. For more than one source, insert it into the tape loop as Brf says, or insert btwn the pre-amp and amp section of the receiver, if there is a pre-out and a main amp in.

for now cd source is what I need, so bam output to cd input on receiver and bam input to analog preamp fr right and left speakers output.
thanks

Swampwalker,
I'm a little mixed up now, should I connect the bam "out" to the cd player or to the receiver's cd input? then from bam to receiver's preamp out?
will I need more than two sets of rca jacks? any wires recommendation?
thanks

For use w one source, connect output of your CD player to BAM input using RCA cables. Connect BAM output to CD input on the AVR using RCA cables. Select CD input on AVR and enjoy.

thank you so much Swampwalker!!