In the last “option 3” example:
- Does one use a specific type of wire? (Like a specific thin silver?)
- Which company peddles the DIN plugs ?
This is the link:
They should be able to answer your questions.
Tone arm plug in RCA cable?
I have a tone arm with a connector that plugs into the bottom of the arm to get the L/R channels from the stereo cart.
There are currently going into a Sumiko Premire PIB 1 box on the side of the deck… The RCAs going to the phono stage are then combing off of that “break out” box.
So a handful of suggestions of phono lines to come off the table would be great to have.
Or do I just get some thin silver wire and twist up some, as they only need to be maybe 10” long (if even that long),
Yeah I did see that right before this:
Yeah really. I know you think it is the worse (or next to unipivot), but I do not appreciate what that means in terms of the way it sounds, or how I could tell other than reading that it sucks.. |
I feel the need to correct an earlier statement made about the Success of the SME Knife Edge Bearing, my prediction of 10's of 1000's is quite short the following is official: Official Factory Production Statistics Series I: 1959-1963, approximately 10,000 built Series II: 1963-1973, approximately 180,000 built Series II Improved: 1973-2003, 260,484 built This Link has loaded better, it is best available to be read with an easy access. There are Two accounts within this Thread, one from the attached link and one from a earlier post, that have content referring to the SME mindset for their Knife Edge Designs. As these accounts are Polar Opposites, it is looking like One Account is with a content that is utter BS and has only been supplied to attempt to Bully an individual into a submission and acceptance of a incorrect statement. My assessment is that the link is containing very accurate information. https://www.tonepublications.com/old-school/sme-3009-tonearm/ |
@holmz : Again you don't read carefully. The knife problem was already explained in your threads by mijostyn and Dr, S.Win. but if that is what you like fine because who have to be satisfied is you not me.
R. |