Best High Current amplifiers stable into low impedances

I may have misinterpreted the OP's question. I believe there is a difference between HIGH CURRENT vs WATTS. Can anyone set me straight on that. I am considering the excellent 150 watt CODA #16 (which is supposed to be high current) vs some other amps that have a lot more watts. Are there scenarios where the CODA #16 could be considered a better match for a 2 Ohm hard to drive speaker vs an amp with more watts?

CODA #16 specs

Maximum current: 100 amperes per channel

Power supply: 3KVA  power transformer/ Dual independent rectification and 280,000 of power supply filter capacitance

“Watt is the measure of power. Volt is the measure of electric potential. Ampere is the measure of current.”

The point is that current is the number of electrons available. Watts is a combined term.

Since output in amps is not generally stated. You get a rough guide by looking at the relationship between watts into different resistance. An amp has lots of current if the number of watts doubles 16 ohms -> 8 ohms -> 4 ohms -> 2 ohms -> 1 ohm. As resistance disappears the amount of current needed to maintain the flow requires a lot more current.

agree w @ghdprentice 

from a practical p-o-v for users sorting through amp choices, the best indicator is if the maker clearly states the amp is able to double wattage from 8 to 4 to 2 ohms... another indicator, less good than the first, is if the amp (at least traditional class a or ab ones) are big and heavy with substantial power transformers and heat sinks - delivering consistently high current flow into low impedance loads generates mucho heat

@jjss49 

Yes. Goes back to the seemingly silly assertion that the heavier the amp, the better it sounds (well actually all audiophile equipment). You need huge power supplies to   Supply current. 
 

After college I was an electrical / mechanical engineer for a while. I welded… low voltage and 5 amps. My first Threshold amp 3.5 amps. Then I got my second top of the line amp A Pass x350. The same amperage as a welder! That is power.

Accuphase A-75 - Class A amplifier.  It is stable down to 1 ohm.  See below: