How to add a subwoofer to a 2 channel stereo

Thanks for the reply. My issue is, the sub sounds less clear if I use dedicated sub amp and split the signal from preamp to amp. However, if I just use one amp, and bi-wire to speaker and this passive subwoofer, the subwoofer is clearer but has lower volume, ie lossed the "punch". 

This old Mcintosh HT2 has two 12 inch subwoofers. Can I add another binding post and turn this mono due subwoofer to a stereo subwoofer? By this way, I may resolve the issue. Any suggestions?

this is why a good powered sub or 2 makes life (and the music) better and easier

I believe the HT2 may have been designed to be used with McIntosh amplifiers/receivers that use their autoformer output stage which has 8 and 4 ohm positive and negative speaker binding posts. 

If your amplifier only has left and right + and - binding posts and your stacking both your tower speakers and the subwoofer cables, this may be responsible for the lower output your hearing.

Refer to the McIntosh HT2 manual as well as a McIntosh amplifier manual or contact McIntosh directly for assistance. 

Guys, Thank you all for your input!