What does Jitter sound like?


I keep hearing the term jitter used to describe a kind of distortion that is especially problematic with CD Players.

What does Jitter sound like?
How can I identify it?
hdomke
Brownsfan - As I have said in other posts, it is the PRIMARY deficiency that makes Digital Audio fatigueing, and is the single most significant flaw in the S/PDIF and CD format.

Steve N.
However, inaccuracies in the pit locations on the CD or CD-R contribute to the PLL clock jitter in the CD player

There is no PLL (Phase Lock Loop) used in a CD player unless it is getting its timing daisy chained down from some external device rather than its own internal clock (say an external SPDIF signal or TosLink signal, however this is not thee usual setup as youu are just using the CD players DAC).

Phase Lock Loops are used between devices in order to maintain synchronization ( for example a CD player and a DSP - the PLL in the DSP will keep in sync with the bit stream from the CD player - some PLL implementations can do a good job of reducing jitter )

Please refer to Page 207 of Nika Aldrich's book "Digital Audio Explained for the Audio Engineer" for an explanatin of a Phase Locked Loop (PLL). I strongly recommend this book to people unfamiliar with digital electronics (you don't need to be an EE to follow it).
The reason I mention comparison between speed fluctuations in TT & digital jitter in CDP is because I experience these phenomena quite differently. As the speed stability of my TT has improved through various upgrades, I hear improved dimensionality, soundstage, bass control, dynamics, liveliness, focus, etc., even though pitch remains audibly imperfect. On this narrow point of pitch stability the CDP surpasses and I suspect will always surpass the TT (as evidenced particularly with piano music.) But somehow the ear is forgiving of even quite audible fluctuations in timing that originate in the analog domain. Perhaps this is because the physical locus of the stylus ensures that timing variations are applied uniformly across all spectra at each point in the LP groove.

In contrast, digital jitter seems to smear timing quite differently and more objectionably so. Having progressed through four generations of clock in my CDP I can say that most of what listeners think is synthetic & irritating about RBCD relates to jitter.
digital jitter seems to smear timing quite differently and more objectionably so. Having progressed through four generations of clock in my CDP I can say that most of what listeners think is synthetic & irritating about RBCD relates to jitter.

Jitter has absolutely no effect on the timing of audio signals....you are misinformed. I suggest you read the book I referenced above rather than make conjecture. Jitter creates side bands or frequencies that are not in the original music - the closest thing to jitter would be IMD distortion - the side bands if big enough and far enough away from the main signal frequency (so as not to be masked) will be audible as non musical related distortion or a higher noise floor.

As far as jitter affecting timing in what you hear - this is impossible unless you are a super bat (I don't even think bats are that good)? Jitter is in the nanosecond and faster range of timing. No human has shown the ability to sense timing delays in this range... in this amount of time sound travels 11 millionths of a foot...there is just no way hearing is that good. Besides - the output filter in the CD players DAC removes frequencies above 22 Khz anyway....so any effect cannot be related to "timing" even if you describe it that way.
Shadorne - how do you think the data coming off the disk is stored in a buffer in the CD player without a PLL?

BTW, I am an EE. I was a design team lead on the Pentium II at Intel Corp. 30 years design experience designing everything from big disk and tape controllers for IBM equipment to massively parallel supercomputers to slot 1 processors.

Steve N.
Empirical Audio