Low buzzing through speaks

Great replies @tkhill ​​​​@strawj! I used the opportunity when I relocated a few things when I introduced the McIntosh to clean and dust-another great call on this thread! You guys truly are awesome! And my Hum-X will arrive Thursday so tomorrow I try plugging the McIntosh into a separate outlet direct and see if that makes the buzz go away. Next step if that doesn’t work is to unplug everything 1 at a time from my Furman Elite. Then plug everything back one at a time to see if it in fact maybe isn’t the McIntosh. But I have already unplugged several components including the 2 subs and the cable box and that didn’t change anything. So I’ll go all the way in tomorrow.

I did disconnect all my XLR IC’s from the Titan amp and there was no buzz so I know it’s not the power amp. My IC’s are all Transparent Plus so I know they’re solid. I really am almost convinced it’s the McIntosh but we’ll dig a bit more tomorrow…

Thank you all once again for supporting and going on this journey with me👍🏻!

It's the Mac preamp.  Happened to me too.  The only solution was to go with another preamp.  

@wanganui  Thank you very helpful! nI just tried my last resort-the Hum-X and nothing! Buzz/hum still there...

Try another you mean other than McIntosh? Are they all prone to this?

The first step is to determine what type of buzz you are hearing: Is it ground, DC, or just the Mac itself. If the buzz is in the speakers or subwoofers,  it is usually some type of ground issue. You should check the outlet with a polarity tester to make the sure there is a proper ground: Next disconnect the modem/router if hard wired. If the buzz is still there, the you can disconnect the mac and see if it goes away: If it is ground issue, a ground loop isolator will usually work, most conditioners do nothing for ground or DC issues from my experience. Also, from my experience in install and sales, most issues are the equipment picking up something either electrical or in the ISP and then passing it through the speakers. So if you send the unit in for service, there is high probability of a no problem found diagnosis.

Thanks @jb1. I don’t think it’s a ground loop. I have literally tried everything. I unplugged everything one component at a time and buzz/hum still there. The only time it went away is when I disconnected all the IC’s between the Mac and my amp. So I know it’s not my amp (only the speaker cables were connected to the amp at that point). It has to be the Mac. Someone else above said they had the same problem and it’s the Mac…it’s definitely livable as you can only hear it when you put your ear within a couple inches of the tweeters. And you cannot hear it while anything is playing🤷‍♂️. That said just knowing it’s there I just can’t seem to get my head around just living with it, but I feel short of selling it, I’ve tried everything that’s been suggested and then some-including taking it to a Mac service center but to your point I’m not sure that will do anything😔…