@jjss49 No doubt!
One has to address both noise and jitter in order to get optimal streaming sound quality. In most cases one will have treated noise issue first since more easily addressed with more affordable devices. If still residual fatigue this very likely due to jitter. Jitter is more difficult to address, add on timing devices can't correct timing, latency issues within streamers/dacs. The jitter has already contaminated the signal, band aids don't close the wound, you could say the same about noise contamination.
So, the point is to do the least harm at each and every point of streaming chain. Per @lollipopguild every single component in chain is important and needs to be optimized. And I do observe those claiming to hear least fatiguing, most optimal streaming quality do have top tier components across entire streaming chain. I observe the best quality streaming comes from the least complex streaming setups using these top tier components, no band aids or add ons. The one exception to this is the single add on of the network devices such as Muon, in my case JCAT net XE. This seems to be critical component as routers certainly noisy and seem to be effective even for those using audiophile switches. By the way, adding audiophile switch was single worst addition to streaming setup ever experienced, YMMV.
There is interesting post here with individual going to second modem/ISP service to exclusively serve audio system. Modem direct ethernet connection to streamer and remote device such as laptop or tablet. Perhaps this setup negates need for network cleaner/filter devices?