As far as whole house surge protection, I would look at installing Environmental Potentials EP-2050 or 2050EE Surge and AC Waveform Correction & EP-2750 Ground Filter in sub or main panel feeding your audio room.
Dedicated Line - Things to consider
Hey all,
So…as far as building my system is concerned, I’m pretty much in a good spot for now with the components and cables. I can say I’m satisfied with the sound. But, as we all know, system building isn’t an action that can ever be completed, it’s a state we’re constantly in.
Right now I have few finishing touches left.
1. Run a dedicated line
2. Improve room acoustics
Wanted to solicit some thoughts on running a dedicated line.
First of all, is it a worthy addition? What are the deciding factors? I realize all the appliances in the house 💩 into the power line, and I use a power conditioner for the source components. Amp is plugged directly into the wall.
Here’s what I have in mind if I’m to go ahead and run a dedicated line - 14 awg solid copper wiring - any particular brand? 20A or 15A circuit? Is it worth running one for the amp and one for source components? Or is using one duplex outlet on a dedicated line sufficient to cover amp and source components?
Would appreciate any thoughts based on experience and lessons learned…what would you do differently if you were to do it again? What improvements should I be expecting?
Thanks in advance for sharing your thoughts!
- ...
- 51 posts total
@audphile1 , I scrolled through my own replies to threads and starting in late October is when I began paying attention to the dedicated circuit threads. I was going to go through and paste the links to all the 'dedicated' threads I have been reading, but for some reason, whenever I try to paste more than one link to a thread on this site, things get all screwy on me. I don't know if it's the site, my ancient computer, or just me, but anyway, here is a thread I found from late October.
I'll go through and paste a couple of more that I found to be interesting/informative, but if you were to go to the amps/preamps forum & the misc audio forum and just start scrolling down several pages, you willrun into several threads on the topic. |
. . . here is one that I started after reading the previous one that I pasted got me wondering about a single circuit vs multiple circuits . . .
and just quite recently, Emergingsoul started a thread in the amps/preamps forum about putting multiple circuits on the same leg of the electrical panel or on both legs . . . I won't paste a link to that one, because it is up pretty near the top of the amps/preamps page. . . .
|
- 51 posts total