Does a brand new electrical circuit for audio gear benefit from burn in/break in time?

These outlets are great built like a tank put these in your audio room for $100

money well spent 

Does a brand new electrical circuit for audio gear benefit from burn in/break in time?

No.

- not sure why you would even conjecture that … but in any case …nope … that is dead wrong … and you lose that wager …full stop. 

- My entire system was fully disconnected into its individual components and then boxed up and stored away for protection during the house renos

- after full Reno completion six-odd weeks later …THEN …all boxed up components and cables were taken out of storage  and finally reconnected again with new dedicated line and outlets  …. and voila … 

Actually, I win. 

Six nines of the time people make changes, they do not reseat all connections, power and signal, before experiencing night and day improvements.

they do not reseat all connections, power and signal

I will certainly give that a try, @ieales  .

There's no such thing as a burn in time, in the sense that an electronic circuit behaves differently after say 100 hours of use.

There can be a temperature effect though. An amplifier (and also other equipment) warms up when switched on. All components slowly reach their stable temperature and the electronic operating point that belongs to that temperature. Depending on the circuit there may or may not be subtle audible differences between cold and warm operating state. Some prefer to keep their gear switched on 24/7.