HT Sound quality - tube versus solid state amplification

@2psyop   I looked for something in your post that I agreed with but found nothing.  

If you think tubes can't be dynamic, you should listen to a better system.

only very high power tube systems are heat problems.  Frankly, they are an aberration that has been developed for insensitive speakers.

My tubes aren't as much heat as my Television.

jumia

your existing or new AVR:

one way to reduce front power needs is to send the low bass to self-powered subs, i.e. keep power needs of front l/r lower, thus easier to use tubes.

IF using self powered sub/subs, fed from AVR, you need to know if in 2 channel mode, preamp front out, is the low bass going to the front or is the low cutout, still going to the sub/s? are they on in 2 channel mode?

new: go for an efficient speaker system so that the option of tubes is easier, and less power/heat is needed for those speakers.

IF efficient front l/r speakers, then you want center/surround of essentially the same sensitivity. then you can refine the output to each speaker individually, in the space

I would not let tube life be a concern, they last a long, long time, many 10,000 hours. 

What I would do, to have confidence in existing and new tubes, is buy an inexpensive tube tester.

Since inheriting a big tube console in 1973, I check mine yearly, just prior to thanksgiving, and keep some spares, think long!!!

Maxwave,  I agree that dynamics are very important in a home theater set up but musicality can take movies to a whole new level.   A really great audiophile system makes the musical scores in movies so much better that it pulls you in to the movie even more.  Both are important in my experience.

Burning potentially expensive tube amp tubes to play TV or movies?  No.  The majority of sound comes from the center channel, which the stereo tube amp has nothing to do with.  I think it’s a total waste of $$$. 

Similar to carlsbad, I use my tube amp (Rogue Stereo 100) to drive my main 2 channel and the fronts, in a 7.1 channel system. My Yamaha AV runs into my RP9 preamp, which is in HT bypass when turned off. At least on the pre side, I’m not burning tube time. I don’t watch a whole lot of movies, so tube time on the power amp doesn’t concern me too much. I also often just run straight 2 channel with movies, from my CPU -> RME ADI2 DAC -> pre -> power. It all sounds very good.