Hales transcendence 8 tweeters

I just order the Dayton ..the one installed right now sounds ok in low volume but sometime I want to listen a little louder and it sounds bright.i should be home this weekend and I will see if I can look at the crossover. thanks

Ejvic,
Once installed give them 40 to 60 hours before getting critical... the worst thing you would need is to change 1 or 2 resistors in your crossover, You will get these to blend quite well. I'll be glad to help with that if you can get the info from your crossover and do the work.
Tim

i tried to open the back of the speaker to get to the x-over but i dont have a tool for that kind of screws,I might just stop by in hardware store to get some toll tomorrow.I really appriciate you helping me on this.

"08-01-14: Timlub
Ejvic,
Once installed give them 40 to 60 hours before getting critical... the worst thing you would need is to change 1 or 2 resistors in your crossover, You will get these to blend quite well. I'll be glad to help with that if you can get the info from your crossover and do the work."

Do you think it would work if you put the resistor directly in the upper binding post like you do on Magnepans?

Hi ZD542,
Not on the binding post... a single resistor will add resistance to the speaker, if added to the tweeter, it will add resistance to the tweeter. If Hales used a single resistor in the crossover as a pad, the resistor is figured into the crossover frequency, If he used 2 resistors as an l-pad, we can simply change these 2 resistors without effecting the crossover at all.... of course, there is a shot that the tweeter sounds pretty good without mods.